We all know we are supposed to call a reliable plumber Liverpool if we have a leaky pipe. But what if you cannot get hold of a plumber on time? That’s when you need to know a few simple tricks to fix a minor leak in your pipe.
And today, in this article, we have come up with a few easy ways you can fix your pipe all by yourself! So let’s get started.
How To Fix A Leaky Pipe?
Without Replacing It
The drainpipes and the P trap, the U-shaped pipe that collects waste and prevents sewage gases from entering your property, are connected by coupling nuts. A leaky pipe in your bathroom or kitchen could be due to a crack or break, but a loose coupling nut joining the pipes is also a common cause of leaks. If this is the source of the leak, tighten the connection nut using a wrench from your plumbing equipment. If the leak comes back again, make sure to get a reliable plumber like Just Flow Sydney and have the pipe checked and changed.
With Plumbers Tape
The waterproof seals in the pipe threads may be worn or no longer functional if the place where the pipes join continues to leak after you’ve tightened the coupling nut. Plumber tape is a great way to stop leaks in the middle of the night. The material’s simplicity of use and flexibility make it ideal for leaking pipe repairs on threads and fittings. Here’s how you can do it –
- Remove the coupling nut that connects the P trap to the sink drain pipe. Remove the P trap from the draining pipe by loosening the other coupling nut.
- Tie a piece of plumber’s tape around the pipe threads according to the manufacturer’s directions.
- Connect the pipes with the coupler after repositioning the P trap with the draining pipe. Make sure to tighten the coupling nuts.
- Lastly, run the water and check if the sealing has been adequately done.
- With Self-fusing Silicone Tape
Most plumbers in Liverpool also use self-fusing silicone tape to fix low-pressure lines. You can wrap the tape around the pipe, expanding it as much as possible to create overlapping tight passes to cover the leak area. The tape creates a perfect waterproof layer even when it is stretched.
With Epoxy Putty
Use epoxy or pipe putty as a temporary remedy for a leaking pipe. At standard temperature, pipe putty hardens to seal the hole or crack. Here’s how you can use it –
- In the house, switch off the power supply pipe.
- Drain the damaged line and ensure the patched area is clean and dry before applying the epoxy putty.
- Remove sufficient epoxy putty to cover the leak’s surface thoroughly.
- Mix the putty until it is sufficiently malleable to be applied.
- Now put the putty on the pipe.
- As directed by the manufacturer, turn on the water flow and check for leaks after the putty has fully hardened.
The tips, as mentioned above, are straightforward ways of fixing a leaky pipe all by yourself. You need to know the technique and the materials to use, and you are good to go! So the next time you see your pipe leaking, refer to this article, and you are saved!